//
|
Yes it is, due to PlantMESH technology - don't try this with anything else! PlantMESH actually has better redundancy than a normal wired ethernet plant network, as PlantMESH has mutliple paths it can take across the network to get where it needs. A wired network has just one, and if something happens to the cable or connector, or switch port... your process is down. Here are a few more reasons why PlantMESH works so well in factory environments: PlantMESH is Secure, Redundant and Fault Tolerant. 256 bit encrypted SSH tunnels between each PlantMESH unit, and your choice of 128 or 256 bit wireless encryption to the clients or a hard wired connection via a MeshNODE. The Layer 3 routing algorithm identifies when a node stops working and re-routes traffic to the next best path automatically, providing fail safe operation.
|
|
|
ZERO Configure Install. Plug in the MeshCore, power up some MeshNodes and MeshStations, then turn on your laptop. is not only working but it's also optimized! (Don't worry, if you really want to, once everything is hooked up, you can tune it to your hearts content.) PlantMESH is Fast and Expandable. Unlike other Mesh systems, PlantMESH can handle virtually as many nodes as you want to install, because is always checking the best path for traffic, and ONLY sends actual traffic over that path. Conventional Mesh systems send all traffic to all nodes, limiting most systems to between four and six nodes before speed drops off drastically. PlantMESH can Expand to other plants, outdoor areas, and even vehicle traffic like forklifts and Autonomous Guided Vehicles. PlantMESH can connect two locations up to 4 miles away, span an entire compound of many square miles and can even be located on local vehicle traffic. PlantMESH connects legacy devices. Got an old Plant PC? Stick a wireless card in it and you are on the PlantMESH network. As long as your device has an ethernet card available, even an old one, you can locate a MeshNODE close to it and plug it right in to the network. |
|